NO TOOLS • EASY SNAP-IN INSTALLATION SAVES TIME!
FOR NEW OR RETROFIT INSTALLATIONS
SNAP2IT® CONNECTORS Made in USA
Arlington’s new one-piece RETROFIT SNAP2IT® fittings are
easy to use in OLD or NEW WORK installations, and handle
the widest variety of cables! They’re ideal for adding
additional circuits to a load center. And you get the same
labor-savings in a retrofit installation!
Easy snap-in installation - NO TOOLS. Install connector
into the knockout in an existing box, pulling cable/
conduit through the knockout. Slip the fitting onto the
cable, then snap the assembly into the box. That’s it...
a secure installation with no pullout.
Widest total cable ranges; Widest variety of cables
14/2 to 10/3 AC, MC, HCF, MC continuous corrugated
aluminum cable, MCI-A cables (steel and aluminum),
AC90, ACG90 and FLEX
into box. Done!
38RAS T Connectors with Built-in Ground
38RASTG front 40RASTG back
for NEW and RETROFIT work
REV 1_ 2 ad Retrofit Snap2It_1/2 pg ad LPCG 12/11/15 11: 26 AM Page 1
NON-METALLIC • RETROFIT OR NEW WORK
Patent pending Made in USA
PUSH IN CONNECTOR
FOR NM AND FLEXIBLE CORD INSTALLATIONS
NEW Arlington’s NMR840 offers easy,
push-in installation in an installed box
in an existing wall – or a new work box.
NMR840 installs from INSIDE the box
or from OUTSIDE the box.
Installation is easy and secure!
Once inserted into the connector slot
and locked down, the wedge holds
cable securely in place...no pullout!
For NM and flexible cord .350" to .490"
( 1) 14/2 flat to ( 1) 10/3 round cable
( 2) 14/2 to ( 2) 12/2 flat cables
( 1) 14/3 to ( 1) 10/3 flat cable
( 2) 14/3 to ( 2) 12/3 flat cables
( 1) 14/3 to ( 1) 10/3 round cable
1_ 2 ad NMR840 B_1/2 pg ad LPCG 10/9/15 10: 29 AM Page 1